Callout |
Component Name |
---|---|
Preliminary Procedure
Remove the liftgate trim finish panel. Refer to Liftgate Trim Finish Panel Replacement. |
|
1 |
Rear End Spoiler Nut (Qty:?€‰3) Caution: Refer to Fastener Caution.
5.0?€‰Y (44?€‰lb?€‰in) |
2 |
Rear End Spoiler Screw (Qty:?€‰4) Tighten
1.5?€‰Y (13?€‰lb?€‰in) |
3 |
Clip Button Tip: Upon assembly of the rear spoiler to the liftgate, position and secure the clip button to the rear liftgate spoiler to liftgate outer panel first. |
4 |
Rear End Spoiler Assembly |
Doing Your Own Service Work
Warning
It can be dangerous to work on your vehicle if you do not have the proper
knowledge, service manual, tools, or parts. Always follow owner manual procedures
and consult the service manual for your vehicle before doing any service work.
If doing some of your own service work, use the pro ...
Ignition Coil Replacement
Special Tools
EN-6009 Remover and Installer Ignition Coil
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the engine wiring harness guide (1) from the cylinder head.
Disconnect the ignition coil electrical connector (2).
...
Camshaft Timing Chain Replacement
Special Tools
EN-955 Locking Pin
For equivalent regional tools. Refer to Special Tools.
Removal Procedure
Remove the engine front cover. Refer to Engine Front Cover with Oil
Pump Replacement.
Note: If EN-955 fixing pin can not be inserted, compress the
ti ...