|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the rear license plate lamp housing. Refer to Rear License Plate Lamp Replacement. |
|
|
1 |
License Plate Lamp Socket Procedure
Rotate the electrical lamp socket a quarter turn counter-clockwise and remove from the lamp housing. |
|
2 |
License Plate Lamp Bulb Procedure
Pull the bulb straight out of the electrical lamp socket. |
Parking and Turn Signal Lamp Bulb Replacement
Rear License Plate Lamp Bulb Replacement (Sedan)Headlamps, Front Turn Signal and Parking Lamps
Passenger Side Shown, Driver Side Similar
High-Beam Headlamp
Low-Beam Headlamp
Parking/Turn Signal Lamps
High-Beam Headlamp/Low-Beam Headlamp
Open the hood. See Hood.
For the driver side bulb, remove the windshield washer bottle filler
neck by turning it one-quarter ...
2-6 Clutch Piston Installation (6T40/45/50)
2-6 Clutch Piston Installation
Callout
Component Name
1
2?E Clutch Piston Assembly
Note:
Position the 2?E piston air bleed and large slot toward the
top of the case.
DT-47796 seal protector ...
Front Wheel Drive Shaft Seal Replacement - Left Side
Special Tools
DT-446 Installer Drift
DT-7004 Slide Hammer
DT-23129 Universal Seal Remover
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
Remove the front suspension s ...