Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Rear Seat Back Bolster Replacement

Chevrolet Sonic Repair Manual / Body / Seating / Seats / Rear / Rear Seat Back Bolster Replacement



Rear Seat Back Bolster Replacement

Callout

Component Name

Preliminary Procedures

Disable the SIR system. Refer to SIR Disabling and Enabling

1

Rear Seat Back Cushion Bolster

Warning:

Refer to SIR Warning

Warning:

Do not repair or replace the seat stitching or seams in the seat back trim cover with an internal mounted seat side airbag module. Replace the complete seat back trim cover from the OEM. Non-OEM seat stitching may cause improper airbag deployment which could result in personal injury.

Procedure

  1. Pull bolster very hard from top to disengage retainers.
  2. Replace all damaged retainers and tap back holes in body sheet metal, if necessary.
  3. Disconnect electrical connector.
  4. Remove rear seat back cushion bolster.
  5. Remove the rear seat side inflatable module, if equipped. Refer to Rear Seat Outboard Seat Back Airbag Replacement
Body Rear Seat Back Trim Panel Replacement (with AMA/AM7)
Body Rear Seat Back Trim Panel Replacement Callout Component Name Preliminary Procedure Remove the body side trim panel. Refer ...

Rear Seat Back Cushion Cover and Pad Replacement (AMA 60% w/Split Back)
Rear Seat Back Cushion Cover and Pad Replacement Callout Component Name Preliminary Procedure Remove the rear seat back cushion. Re ...

Other materials:

Air Conditioning Compressor Bracket Installation
Install the air conditioning compressor bracket (2). Caution: Refer to Fastener Caution. Install the 3 air conditioning compressor bracket bolts (1) and tighten to  22 Y (16 lb ft). ...

Camshaft Sprocket Installation
Install the intake camshaft sprocket (3). Install the intake camshaft position sensor exciter wheel (2) and the intake camshaft sprocket bolt (1), but do not tighten yet. Install the exhaust camshaft sprocket. Note: Tightening of camshaft sprocket bolts will ...

Gears Cleaning and Inspection (Gen 1)
Gears Warning: Wear safety glasses to avoid injury when using compressed air or any cleaning solvent. Bodily injury may occur if fumes are inhaled or if skin is exposed to chemicals. Clean the following gears in a suitable solvent and air dry all the p ...

В© 2014-2026 Copyright www.csmans.com
 
0.006