|
Callout |
Component Name |
|---|---|
|
1 |
Rear Seat Back Cushion Latch Release Handle Bezel Procedure
Use a flat-bladed tool to tilt the rear of the handle upward, then lifting and pulling the bezel rearward to disengage the front hooks. |
Rear Seat Back Cushion Hinge Replacement
Rear Seat Back Cushion Panel ReplacementCruise Control
: Press to turn the cruise control
system on and off.
RES/+: Move the thumbwheel up briefly to make the vehicle resume to a previously
set speed or hold upwards to accelerate. If cruise control is already active, use
to increase vehicle speed.
SET/−: Move the thumbwheel down briefly ...
Steering Angle Sensor Centering
The steering angle sensor does not require centering often. Centering of the
steering angle sensor might be required after certain service procedures are performed.
Some of these procedures are as follows:
Wheel alignment
Steering gear replacement
Steering column replacement
Collision ...
Engine Coolant Thermostat Housing Replacement (LUW)
Removal Procedure
Remove the battery tray. Refer to Battery Tray Replacement.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Drain the cooling system. Refer to Cooling System Draining and Filling.
Disconnect the engine harness conn ...