Callout |
Component Name |
---|---|
Preliminary Procedure
Remove the rear seat back cushion. Refer to Rear Seat Back Cushion Removal and Installation |
|
1 |
Rear Seat Back Outer Pivot Bolt (Qty:?€‰2) Caution: Refer to Fastener Caution.
23?€‰Y (17?€‰lb?€‰ft) |
2 |
Rear Seat Back Cushion Outer Pivot Bushing |
3 |
Rear Seat Back Cushion Outer Pivot Bolt Spring |
4 |
Rear Seat Back Cushion Pivot Support Housing |
5 |
Rear Seat Back Center Finish Cover |
When to Add Engine Oil
1.8L Shown, 1.4L Similar
If the oil is below the minimum mark on the dipstick, add 1 L (1 qt) of the recommended
oil and then recheck the level. See “Selecting the Right Engine Oil” in this section
for an explanation of what kind of oil to use. For engine oil crankcase capacity,
see Cap ...
Engine Flywheel Removal
Special Tools
EN-652 Flywheel Holder
For equivalent regional tools, refer to Special Tools.
Install EN-652 holder (1) to hold the engine flywheel (2).
Remove and DISCARD the 6 engine flywheel bolts (2).
Remove the engine flywheel (1).
...
Backup Lamp Switch Replacement
Backup Lamp Switch Replacement
Callout
Component Name
Preliminary Procedure
Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection.
Without draining the coolant or removing ...