Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Rear Seat Back Cushion Removal and Installation (40%)

Chevrolet Sonic Repair Manual / Body / Seating / Seats / Rear / Rear Seat Back Cushion Removal and Installation (40%)



Rear Seat Back Cushion Removal and Installation

Callout

Component Name

Preliminary Procedure

  1. Remove the rear seat cushion. Refer to Rear Seat Cushion Removal and Installation.
  2. Remove the rear seat back cushion bolster. Refer to Rear Seat Back Bolster Replacement

1

Rear Seat Back Cushion Pivot Support

Procedure

  1. Pull the rear seat back cushion latch release located on the top of the rear seat back cushion, and fold the rear seat back cushion forward.
  2. Push in on the rear seat back cushion pivot support, and release from bracket.

2

Rear Seat Back Cushion

Procedure

  1. Pull up on the outer side of the rear seat back cushion and remove the rear seat back cushion from the bracket and hinge.
  2. Transfer components as necessary.
Rear Seat Back Cushion Pivot Support Replacement
Rear Seat Back Cushion Pivot Support Replacement Callout Component Name Preliminary Procedure Remove the rear seat back cushion ...

Rear Seat Back Cushion Removal and Installation (60%)
Rear Seat Back Cushion Removal and Installation Callout Component Name Preliminary Procedure Remove the rear seat cushion. Refer to ...

Other materials:

How Does an Airbag Restrain?
In moderate to severe frontal or near frontal collisions, even belted occupants can contact the steering wheel or the instrument panel. In moderate to severe side collisions, even belted occupants can contact the inside of the vehicle. Airbags supplement the protection provided by safety belts ...

Front Fog Lamp Bulb Replacement
Front Fog Lamp Bulb Replacement Callout Component Name Preliminary Procedure Remove either the left front or right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement. Disconnect the electrical connector t ...

Lock Cylinder Coding - Ignition
The ignition lock cylinder uses 8 key cut positions, 1?E. The ignition cylinder tumblers (3) are located on alternate sides of the cylinder (5). They are not snap-in and are not self-retaining. It follows the key code with the first tumbler being the first depth of the ke ...

В© 2014-2025 Copyright www.csmans.com
 
0.0107