|
Callout |
Component Name |
|---|---|
|
1 |
Rear Seat Head Restraint Preliminary Procedures
|
Rear Seat Head Restraint Guide Replacement
Seat ControlsEmblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Sunroof Window Height and Opening Fit Adjustment
Note: Correct adjustment cannot be achieved if the sunroof window
is closed from vent position.
Cycle the sunroof window from full open to closed position.
.,
Note: Do Not remove or lower headliner to access sunroof window
screws.
Loosen the adjusting screws on ...
Replacement Wheels Description
Replace the wheel if any of the following conditions exist:
The wheel exhibits excessive runout.
The wheel is bent.
The wheel is cracked.
The wheel is severely rusted.
The wheel is severely corroded.
Note: Air leaks caused by porosity on aluminum wheels are repairable.
...