Chevrolet Sonic Repair Manual: Rear Seat Shoulder Belt Guide Opening Bezel Replacement
|
Callout |
Component Name |
|---|---|
|
1 |
Rear Seat Shoulder Belt Opening Bezel Procedure
Push inward and upward from the front of the bezel to release from the seat back. Note: The rear seat shoulder belt opening bezel is part of the rear seat center belt assembly and is replaced as an assembly. |
Rear Seat Center Shoulder Belt Replacement (Sedan)
Rear Seat Center Shoulder Belt Replacement
Callout
Component Name
Preliminary Procedures
Remove the rear seat cushion. Refer to ...
Repairs and Inspections Required After a Collision
Warning: Restraint systems can be damaged in a collision. To help
avoid injury and ensure that all parts in need of replacement are replaced:
Replace any seat belt system that was in us ...
Other materials:
Programming Transmitters to the Vehicle
Only RKE transmitters programmed to this vehicle will work. If a transmitter
is lost or stolen, a replacement can be purchased and programmed through your dealer.
When the replacement transmitter is programmed to this vehicle, all remaining transmitters
must also be reprogrammed. Any lost or s ...
Clutch Actuator Cylinder Front Pipe Replacement
Removal Procedure
Remove the battery tray. Refer to Battery Tray Replacement.
Remove as much brake fluid out of brake fluid reservoir as possible.
Unclip the clutch actuator cylinder front pipe from the 2 retainers (1).
Remove the retaining ...
Ignition Coil Replacement
Special Tools
EN-6009 Remover and Installer Ignition Coil
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the engine wiring harness guide (1) from the
cylinder head.
Disconnect the ignition coil electrical connector (2).
...
0.0067