The vehicle's rear seats have adjustable head restraints in the outboard seating positions.

The height of the head restraint can be adjusted. Pull the head restraint up to raise it. Try to move the head restraint to make sure that it is locked in place.
To lower the head restraint, press the button, located on the top of the seatback, and push the head restraint down. Try to move the head restraint after the button is released to make sure that it is locked in place.
Rear outboard head restraints are not designed to be removed.
Front Seats
Front SeatsHeater Outlet Hose Replacement (LDE, LUW)
Special Tools
BO-38185 Hose Clamp Pliers
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Drain the cooling system. Refer to Cooling System Draining and Filling.
Disengage the heater outlet hose quick connect clip (1) at the heater ...
Service Prior to Assembly
The importance of cleanliness during assembly cannot be overstated. Dirt or debris
will cause engine damage. An automobile engine is a combination of many machined,
honed, polished and lapped surfaces with minor tolerances. When any internal engine
parts are serviced, care and cleanliness are ...
Front Wheel Drive Shaft Seal Replacement - Left Side
Special Tools
DT-446 Installer Drift
DT-7004 Slide Hammer
DT-23129 Universal Seal Remover
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
Remove the front suspension s ...