Callout |
Component Name |
---|---|
Preliminary Procedure
Remove the rear seat cushion. Refer to Rear Seat Cushion Removal and Installation. |
|
1 |
Rear Side Door Opening Floor Carpet Retainer Assembly |
Emblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Power Steering Control Module Programming and Setup
The following service procedures require either a programming or a setup event
performed for a complete repair.
Power Steering Control Module Replacement
If the steering column power steering control module needs to be is replaced,
the power steering control module needs to be progra ...
Evaporative Emission System Hose/Pipe Replacement
Special Tools
CH-807 Closure Plugs
CH-6015 Closure Plugs
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Warning: Refer to Gasoline/Gasoline Vapors Warning.
Disconnect the battery negative cable. Refer to Battery Negative Cable
Disconnec ...