Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Rear Side Door Stationary Window Replacement

Chevrolet Sonic Repair Manual / Body / Doors and Enclosures / Doors / Rear Side Door Stationary Window Replacement



Rear Side Door Stationary Window Replacement

Callout

Component Name

Warning:

Refer to Glass and Sheet Metal Handling Warning.

Preliminary Procedures

Remove the rear side door window. Refer to Rear Side Door Window Replacement.

1

Rear Side Door Window Weatherstrip Lower Bolt

Caution:

Refer to Fastener Caution.

Tighten


9?€‰Y (80?€‰lb?€‰in)

Tip:

The weatherstrip and window is serviced as one assembly.

2

Rear Side Door Window Weatherstrip Upper Screw

Procedures

  1. Pull the weatherstrip out of the upper retainer to expose the screw.
  2. Remove the weatherstrip from the front and rear lower guides.
  3. Grasp both upper corners, pull forward releasing assembly from the door frame.
Tighten


3?€‰Y (27?€‰lb?€‰in)

3

Rear Side Door Window Weatherstrip

Procedures

  1. Insert the weatherstrip downward in the guide until fully seated.
  2. Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the guides.
  3. Inspect the door window for proper operation before installing the door trim panel.
Rear Side Door Replacement
Rear Side Door Replacement Callout Component Name Warning: Refer to SIR Warning. Preliminary Procedures Mark the l ...

Rear Side Door Trim Replacement (Hatchback)
Rear Side Door Trim Replacement Callout Component Name Preliminary Procedure Remove the rear side door upper rear trim panel. R ...

Other materials:

Turning the System On or Off
/VOL (Power/Volume): Press to turn the system on and off. Automatic Switch-Off If the infotainment system is on after the ignition is turned off, the system will turn off automatically after 10 minutes. Volume Control /VOL (Power/Volume): Turn to adjust the volume. (Phone/Mute): For ve ...

HVAC System Control Module Programming and Setup
Note: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the control module is not properly configured with the correct calibration software, the control module will not control all of the vehicle features properly. Ensure th ...

Gears Cleaning and Inspection (Gen 1)
Gears Warning: Wear safety glasses to avoid injury when using compressed air or any cleaning solvent. Bodily injury may occur if fumes are inhaled or if skin is exposed to chemicals. Clean the following gears in a suitable solvent and air dry all the p ...

© 2014-2022 Copyright www.csmans.com
 
0.0069