Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Rear Side Door Upper Front Auxiliary Weatherstrip Retainer Replacement

Chevrolet Sonic Repair Manual / Body / Doors and Enclosures / Doors / Rear Side Door Upper Front Auxiliary Weatherstrip Retainer Replacement



Rear Side Door Upper Front Auxiliary Weatherstrip Retainer Replacement

Callout

Component Name

1

Front Side Door Upper Front Auxiliary Weatherstrip Retainer (Qty:?€‰10)

Note:

If the retainers are damaged when removing they must be replaced.

2

Front Side Door Upper Front Auxiliary Weatherstrip Retainer

Procedure

  1. Rear side door weatherstrip door side. Refer to Rear Side Door Weatherstrip Replacement - Door Side.

    It is only necessary to remove the upper second of the weatherstrip from the door to replace the weatherstrip retainer.

  2. Starting in the center top of the weatherstrip, pull the weatherstrip upward and away from the door retainer.
  3. Inspect the door for proper operation and sealing.
Rear Side Door Trim Replacement (Sedan)
Rear Side Door Trim Replacement Callout Component Name 1 Rear Side Door Inside Handle Bolt Cap 2 ...

Rear Side Door Upper Hinge and Lower Hinge Replacement
Rear Side Door Upper Hinge and Lower Hinge Replacement Callout Component Name 1 Rear Side Door Upper Hinge to Body Bolts ...

Other materials:

Heated Seat Control Module Programming and Setup
The seat heating control module must be programmed with the proper calibration software. The module stores and utilizes this information however if it is not properly configured with the correct calibration software, the seat heating control module will not control all of the vehicle features ...

Engine Front Cover and Oil Pump Assemble
Oil Pump Installation Note: The oil pump slide spring and pin, as well as the slide seal and slide seal spring can be ordered as single parts. All other oil pump components can only be ordered as a replacement kit. Install the oil pump components in the fo ...

Main Shaft Disassemble (Gen 2)
Special Tools 69604356 Gear Pullers For equivalent regional tools, refer to Special Tools. Remove the 1st gear thrust washer (1) and the 1st gear (2) using 69604356 pullersand a hydraulic press. ii Remove the following components: 1st gear bearing asse ...

© 2014-2022 Copyright www.csmans.com
 
0.0071