Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Rear Side Door Window Regulator Motor Replacement

Chevrolet Sonic Repair Manual / Body / Glass & Windows / Window Control / Window Power Motor / Rear Side Door Window Regulator Motor Replacement



Rear Side Door Window Regulator Motor Replacement

Callout

Component Name

Warning:

Refer to Glass and Sheet Metal Handling Warning.

Preliminary Procedure

Remove the rear side door window regulator. Refer to Rear Side Door Window Regulator Replacement.

1

Rear Side Door Window Regulator Motor Screw (Qty:?€‰3).

Caution:

Refer to Fastener Caution.

Procedure

  1. Remove the rear side door water deflector.
  2. Remove the rear side door window from the guide. Do Not remove the window from the vehicle, raise the window to the fully up position, tape in place.
  3. Disconnect the electrical connector from the window regulator motor.
Tighten


5?€‰Y?€‰(44?€‰lb?€‰in)

2

Rear Side Door Window Regulator Motor

Procedure

Inspect the door window for proper operation before installing the door trim panel.

Front Side Door Window Regulator Motor Replacement
Front Side Door Window Regulator Motor Replacement Callout Component Name Warning: Refer to Glass and Sheet Metal Handling War ...

Window Motor Programming - Express Function
Window Motor Normalized Procedure A window motor that has not been normalized will no longer perform the express up and express down functions, this may occur during the following conditio ...

Other materials:

Vehicle Alarm System
This vehicle has an anti-theft alarm system. The indicator light on the instrument panel near the windshield indicates the status of the system. Off: Vehicle is disarmed. On Solid: Vehicle is secured during the delay to arm the system. Fast Flash: Vehicle is unsecured. A door, the hood, or t ...

Headlamp Bulb Replacement
Headlamp Bulb Replacement Callout Component Name Preliminary Procedure Open and support the hood assembly. 1 Accessory Bulb Cover?€‰(Qty:?€‰2) 2 Warning: Refe ...

Tire-to-Wheel Match-Mounting (Vectoring)
Note: After remounting a tire to a wheel or after replacing a tire and/or a wheel, remeasure the tire and wheel assembly runout in order to verify that the amount of runout has been reduced and brought to within tolerances. Ensure that the tire and wheel assembly is properly balanced ...

© 2014-2026 Copyright www.csmans.com
 
0.0068