Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Rear Side Door Window Regulator Replacement (Hatchback)

Chevrolet Sonic Repair Manual / Body / Doors and Enclosures / Doors / Rear Side Door Window Regulator Replacement (Hatchback)



Rear Side Door Window Regulator Replacement

Callout

Component Name

Warning:

Refer to Glass and Sheet Metal Handling Warning.

Preliminary Procedure

Remove the front side door window from the guide. Do not remove the window from the vehicle, raise the window to the fully up position, tape in place. Refer to Rear Side Door Window Replacement.

1

Rear Side Door Window Regulator Screw (Qty:?€‰3)

Caution:

Refer to Fastener Caution.

Procedure

  1. Remove the rear side door water deflector.
  2. Loosen the window guide nuts. Do not remove the nuts from the guide.
  3. Disconnect the door electrical connector.
  4. Remove the rear side door window from the guide. Refer to Rear Side Door Window Rear Guide Replacement.

    Do not remove the window from the vehicle, raise the window to the fully up position, tape in place.

Tighten


11?€‰Y?€‰(97?€‰lb?€‰in)

2

Rear Side Door Window Regulator

Procedure

  1. Transfer the rear side door window regulator motor. Refer to Rear Side Door Window Regulator Motor Replacement.
  2. Inspect the door window for proper operation before installing the door trim panel.
Rear Side Door Window Regulator Motor Replacement
Rear Side Door Window Regulator Motor Replacement Callout Component Name Warning: Refer to Glass and Sheet Metal Handling Warn ...

Rear Side Door Window Regulator Replacement (Sedan)
Rear Side Door Window Regulator Replacement Callout Component Name Warning: Refer to Glass and Sheet Metal Handling Warning. ...

Other materials:

Brake Drum Surface and Wear Inspection
Special Tools CH-8001 Dial Indicator Set For equivalent regional tools, refer to Special Tools. Warning: Refer to Brake Dust Warning. With the brake drum removed, clean the brake shoe lining contact surface of the brake drum with denatured alcohol or an equivalent approved brak ...

Tire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
Note: After remounting a tire and wheel assembly to a hub/axle flange, remeasure the tire and wheel assembly on-vehicle runout in order to verify that the amount of runout has been reduced and brought to within tolerances. Mark the location of the high spot on the tire and wheel asse ...

Main Shaft Disassemble (Gen 2)
Special Tools 69604356 Gear Pullers For equivalent regional tools, refer to Special Tools. Remove the 1st gear thrust washer (1) and the 1st gear (2) using 69604356 pullersand a hydraulic press. ii Remove the following components: 1st gear bearing asse ...

© 2014-2025 Copyright www.csmans.com
 
0.0069