|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the rear side door window switch bezel. Refer to Rear Side Door Window Switch Bezel Replacement. |
|
|
1 |
Rear Side Door Window Switch Assembly Procedure
|
Rear Side Door Window Switch Bezel ReplacementFog Lamps (RS)
To replace the front fog lamp bulb:
Locate the fog lamp located under the front fascia.
Remove the cap from the back of the fog lamp assembly.
Disconnect the electrical connector from the fog lamp bulb assembly.
Remove the bulb by turning it counterclockwise and pulling it straight out ...
Steering Angle Sensor Centering
The steering angle sensor does not require centering often. Centering of the
steering angle sensor might be required after certain service procedures are performed.
Some of these procedures are as follows:
Wheel alignment
Steering gear replacement
Steering column replacement
Collision ...
Tire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
Note: After remounting a tire and wheel assembly to a hub/axle flange,
remeasure the tire and wheel assembly on-vehicle runout in order to verify that
the amount of runout has been reduced and brought to within tolerances.
Mark the location of the high spot on the tire and wheel asse ...