Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Rear Side Door Window Weatherstrip Replacement (Sedan)

Chevrolet Sonic Repair Manual / Body / Doors and Enclosures / Doors / Rear Side Door Window Weatherstrip Replacement (Sedan)



Rear Side Door Window Weatherstrip Replacement

Callout

Component Name

Preliminary Procedures

  1. The rear door side window weatherstrip and window is serviced as one assembly. Refer to Rear Side Door Stationary Window Replacement.
  2. Remove the rear side door window . Refer to Rear Side Door Window Replacement.

1

Rear Side Door Window Weatherstrip Lower Bolt

Caution:

Refer to Fastener Caution.

Procedure

Remove the rear side door water deflector.

Tighten


9?€‰Y (80?€‰lb?€‰in)

2

Rear Side Door Window Weatherstrip Upper Screw

Procedure

  1. Pull the door weatherstrip out of the upper retainer to expose the screw.
  2. Remove the weatherstrip from the front and rear lower guides.
  3. Grasp both upper corners, pull downward releasing the weatherstrip from the door frame.
Tighten


3?€‰Y (27?€‰lb?€‰in)

3

Rear Side Door Window Weatherstrip

Procedure

  1. Insert the weatherstrip downward in the guide until fully seated.
  2. Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the guides.
  3. Inspect the door window for proper operation before installing the door trim panel.
Rear Side Door Window Weatherstrip Replacement (Hatchback)
Rear Side Door Window Weatherstrip Replacement Callout Component Name Preliminary Procedure Remove the rear side door window . ...

Remote Control Door Lock Receiver Programming and Setup
Diagnostic Aids The remote control door lock receiver only functions as an antenna, receiving the signals sent by the keyless entry transmitter and forwarding them to the body control m ...

Other materials:

Driver or Passenger Seat Cushion Frame Replacement
Driver or Passenger Seat Cushion Frame Replacement Callout Component Name Preliminary Procedures Remove the driver or passenger seat. Refer to Driver or Passenger Seat Removal and Installation Remove the front seat cushio ...

Valve Guide Reaming, and Valve and Seat Grinding
Valve Cleaning Procedure Use soft bristle wire brush to clean any carbon build-up from the valve head. DO NOT use a wire brush on any part of the valve stem. The valve stem is chrome plated to provide enhanced wear characteristics. Wire brushing the stem could remove the chr ...

Crankshaft Balancer Replacement
Special Tools EN-470–B Angular Torque Wrench EN-49979 Crankshaft Shock Mount Retainer For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove front wheelhouse liner exten ...

© 2014-2026 Copyright www.csmans.com
 
0.0048