Chevrolet Sonic Owner's Manual: Rear Vision Camera (RVC)
This vehicle may have the RVC system. Read this entire section before using it.
The RVC system can assist the driver when backing up by displaying a view of the area behind the vehicle.
Warning
The RVC system does not display children, pedestrians, bicyclists, animals, or any other object located outside the camera's field of view, below the bumper, or under the vehicle. Perceived distances may be different from actual distances. Do not back the vehicle using only the RVC screen, during longer, higher speed backing maneuvers, or where there could be cross traffic. Failure to use proper care before backing may result in injury, death, or vehicle damage. Always check behind and around the vehicle before backing.
An image appears on the infotainment screen when the vehicle is shifted into R (Reverse). The infotainment screen goes to the previous screen after approximately 4 seconds once the vehicle is shifted out of R (Reverse).
To return to the previous screen sooner, do one of the following:
- Shift into P (Park).
- Reach a vehicle speed of 8 km/h (5 mph).
Guidelines
The RVC system has a guideline overlay that can help the driver align the vehicle when backing into a parking spot.
To turn the guidelines on or off:
1. Shift into P (Park).
2. From the home page on the infotainment system, select Settings.
3. Select Rear Camera Options.
4. Select Guidelines.
Rear Vision Camera Error Messages
SERVICE REAR VISION CAMERA SYSTEM: This message can display when the system is not operating properly.
If any other problem occurs or if a problem persists, see your dealer.
Cleaning the System
If the FCA system does not seem to operate properly, clean the outside of the
windshield area in front of the camera sensor before considering taking the vehicle
in for service. ...
Rear Vision Camera Location
The camera is above the license plate.
The area displayed by the camera is limited. It does not display objects that
are close to either corner or under the bumper and can vary depending on vehic ...
Other materials:
How to Identify Plastic Parts
saepvcsae
Plastic parts can be identified by the SAE code, which is usually found on the
rear of the part, and/or by the characteristics of the plastic. Knowing the type
of plastic aids in selecting the proper repair materials and in selecting the proper
repair procedure.
Look for the SAE ...
Relay Replacement (Within an Electrical Center)
Special Tools
EL-43244 Relay Puller Pliers
Removal Procedure
Remove the electrical center cover.
Note:
Always note the orientation of the relay.
If equipped with a notch style relay; observe the location of
the notch on the old relay to verify the new r ...
Engine Oil Cooler Inlet Pipe Replacement (LUW)
Removal Procedure
Drain the cooling system. Refer to Cooling System Draining and Filling.
Remove the exhaust manifold with catalytic converter. Refer to Exhaust
Manifold with Catalytic Converter Replacement.
Remove the engine oil cooler pipe bolts (1) an ...
0.0059