|
Callout |
Component Name |
|---|---|
Preliminary Procedures
|
|
|
1 |
Rear Wheel Bearing/Hub Mounting Bolt (Qty 4) Caution: Refer to Fastener Caution. Procedure
Remove the electrical connector for the rear wheel speed sensor. Tighten
58 Y (43 lb ft) |
|
2 |
Rear Wheel Bearing/Hub Assembly Procedure
Ensure that the rear wheel bearing/hub is properly aligned with the rear axle to allow access to the wheel speed sensor connector. |
Rear Brake Hose Replacement (Body to Axle - Drum Brake)
Special ToolsMaintenance
Air Intake
Clear away any ice, snow, or leaves from the air intake at the base of the windshield
that can block the flow of air into the vehicle.
Passenger Compartment Air Filter
The filter removes dust, pollen, and other airborne irritants from outside air
that is pulled into the vehicle.
T ...
Front Wheel Drive Intermediate Shaft Replacement
Front Wheel Drive Intermediate Shaft Replacement
Callout
Component Name
Preliminary Procedure
Raise and support the vehicle. Refer to Lifting and Jacking the
Vehicle.
Remove the wheel drive shaft assembly from the vehicle ...
Fuel Tank Fuel Pump Module Replacement
Special Tools
EN-48279 Fuel Sender Lock Ring Tool
For equivalent regional tools, refer Special Tools.
Removal Procedure
Relieve the fuel system pressure. Refer to Fuel Pressure Relief
Remove the fuel tank. Refer to Fuel Tank Replacement.
Disconnect the electrical c ...