Chevrolet Sonic manuals
 

Chevrolet Sonic Repair Manual: Rear Wheel Speed Sensor Replacement

Chevrolet Sonic Repair Manual / Chassis / Brake Control and Vehicle Dynamics / Dynamics Control / Rear Wheel Speed Sensor Replacement

Removal Procedure

Warning:

Refer to Brake Dust Warning.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.


  3. Remove the rear wheel speed sensor harness connector cover nuts (1).

  4. Remove the rear wheel speed sensor harness connector cover (1).
  5. Clean the rear drum brake area around the wheel speed sensor of any accumulated dirt and debris.

  6. Disconnect the wheel speed sensor electrical connector (1) and release the connector from the wheelhouse bracket.
  7. Release the wheel speed sensor harness retainer (2) from the wheel cylinder brake pipe.
  8. Release the wheel speed sensor harness grommets (3) from the bracket.

  9. Remove the wheel speed sensor bolt (1).

  10. Remove the wheel speed sensor (1) from the rear drum brake spacer by pulling the sensor straight upward using a slight twisting motion.
Installation Procedure

    Install the wheel speed sensor (1) to the rear drum brake spacer.
  1. Install the wheel speed sensor (1) to the rear drum brake spacer.

    2. Caution:

    Refer to Fastener Caution.

  2. Install the wheel speed sensor bolt (1) and tighten to 8 Y (71 lb in)

    .



  3. Connect the wheel speed sensor electrical connector (1) and install the connector to the wheelhouse bracket.
  4. Install the wheel speed sensor harness retainer (2) to the wheel cylinder brake pipe.

    5. Note:

    If the wheel speed sensor grommets are equipped with a molded rib, position the grommets with the rib at the open end of the wheel speed sensor harness brackets. Do not twist the wheel speed sensor harness.

  5. Install the wheel speed sensor harness grommets (3) to the bracket.

  6. Install the rear wheel speed sensor harness connector cover (1).

  7. Install the rear wheel speed sensor harness connector cover nuts (1) and tighten to 2 Y (18 lb in)

    .

  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  9. Perform the Diagnostic System Check - Vehicle.
Front Wheel Speed Sensor Replacement
Removal Procedure Warning: Refer to Brake Dust Warning. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the tire and wheel assembly. Refer ...

Special Tools
Illustration Tool Number/ Description EL 35616-F J 35616 Terminal Test Kit ...

Other materials:

Front Side Door Weatherstrip Replacement - Body Side
Front Side Door Weatherstrip Replacement - Body Side Callout Component Name Preliminary Procedures Remove the upper center pillar trim. Refer to Center Pillar Upper Trim Panel Replacement. Remove the lower center pillar t ...

Transmission Identification Information
456789 (1) Code for Automatic Transmission (2) Model Year (3) Model for Transmission (4) Transmission Family (5) Source Code for Plant (6) Calender Year (7) Julian Date ( ...

Backup Lamp Switch Replacement
Backup Lamp Switch Replacement Callout Component Name Preliminary Procedure Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Without draining the coolant or removing ...

В© 2014-2026 Copyright www.csmans.com
 
0.0067