|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. |
|
|
1 |
Rear Wheelhouse Panel Liner Screw (Qty:?€‰4) Caution: Refer to Fastener Caution.
3?€‰Y (27?€‰lb?€‰in) |
|
2 |
Rear Wheelhouse Panel Liner Nut (Qty:?€‰4) Tighten
2?€‰Y (18?€‰lb?€‰in) |
|
3 |
Rear Wheelhouse Panel Liner Push-In Retainer |
|
4 |
Rear Wheelhouse Panel Liner |
Rear Wheelhouse Liner Replacement (Sedan - Left)
Special ToolsVehicle Personalization
Personalization Menu (Radio without
Touchscreen)
Use the audio system controls to access the personalization menus for customizing
vehicle features.
The following are all possible personalization features. Depending on the
vehicle, some may not be available.
CONFIG (Confi ...
Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...
Fuel Tank Fuel Pump Module Replacement
Special Tools
EN-48279 Fuel Sender Lock Ring Tool
For equivalent regional tools, refer Special Tools.
Removal Procedure
Relieve the fuel system pressure. Refer to
Fuel Pressure Relief
Remove the fuel tank. Refer to
Fuel Tank Replacement.
Disconnect the elect ...