Callout |
Component Name |
---|---|
Preliminary Procedure
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. |
|
1 |
Rear Wheelhouse Panel Liner Screw (Qty:?€‰4) Caution: Refer to Fastener Caution.
3?€‰Y (27?€‰lb?€‰in) |
2 |
Rear Wheelhouse Panel Liner Nut (Qty:?€‰4) Tighten
2?€‰Y (18?€‰lb?€‰in) |
3 |
Rear Wheelhouse Panel Liner Push-In Retainer |
4 |
Rear Wheelhouse Panel Liner |
Brake Pedal Position Sensor Calibration
Calibration Criteria
Note: Do not apply the brake pedal during the brake pedal position
sensor calibration procedure. Any movement of the brake pedal during this
procedure will cause the calibration procedure to fail. If this occurs,
the brake pedal position sensor calibrati ...
Rear Brake Caliper Replacement
Removal Procedure
Warning: Refer to Brake Dust Warning.
Warning: Refer to Brake Fluid Irritant Warning.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal
and Install ...
Drive Belt Removal
Special Tools
EN-955 Locking Pins
EN-48488 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Install EN-48488 wrench (1) to the drive belt tensioner.
Note: The drive belt tensioner must always be in a pre-tensioned
state.
Move the dri ...