The rear window defogger system consist of the following components:
The BCM supplies 12?€‰V signal to the rear window defogger switch signal circuit to the HVAC control module. When you depress the rear window defogger switch, the rear window defogger switch pulls the signal circuit low. The BCM interprets as a request for the rear window defogger system. The BCM enables the rear window defogger system by supplying voltage to the rear defogger relay coil. The relay coil supply voltage is also spliced off internally in the BCM to the supply voltage circuit of the rear window defogger indicator. The rear defogger relay is energized and the rear window defogger indicator is illuminated. With the relay energized, battery positive voltage is allowed from the relay switched input through the switch contacts and out the relay switched output to the rear window defogger grid.
When you start the engine and press the rear window defogger switch for the first time, the defogger cycle lasts for 15?€‰minutes. Further operation results in 7.5?€‰minute defogger cycles. The rear defogger feature will not time out if vehicle speed is above 80?€‰km/h (50?€‰mph). The defogger cycle resets to 15?€‰minutes when you cycle the ignition to the OFF position and then to the ON position.
The heated mirrors are also controlled through the rear defogger relay. Whenever the rear window defogger is turned on battery voltage is supplied to the mirror heater elements through the left and right mirror heater element control circuits.
Using the Tire Sealant and Compressor Kit to Temporarily Seal and Inflate a
Punctured Tire
When using the tire sealant and compressor kit during cold temperatures, warm
the kit in a heated environment for five minutes. This will help to inflate the
tire faster.
If a tire goes flat, avoid further tire and wheel damage by driving slowly to
a level place. Turn on the hazard warning fl ...
Tire and Wheel Install Instruction
Installation Instructions Part Number
19156306
Note: Please read the following instructions carefully before mounting
the wheels on the vehicle.
Labels
Your application may require a new tire inflation pressure and mass label. This
label is provided as a guide for tire inflation pre ...
Knock Sensor Replacement
Knock Sensor Replacement
Callout
Component Name
Preliminary Procedures
Disconnect battery negative cable. Refer to
Battery Negative Cable Disconnection and Connection.
Raise and support the vehicle. Refer to
...