|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the inside high mount stop lamp. Refer to High Mount Stop Lamp Replacement. |
|
|
1 |
Rear Window Washer Nozzle Procedure
|
Windshield Washer Solvent Container Replacement
Windshield Washer Nozzle Hose ReplacementMulti-Axis Acceleration Sensor Module Programming and Setup
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the Multi-axis Acceleration Sensor or Inertia
Sensor Module (IMU) is not properly configured with the correct calibration
software, the Electronic Brake Control Module will ...
Tire and Wheel Balancing (Wheel Pilot Bore Greasing)
Beginning with MY 2011 vehicle, pilot bore grease should be applied.
To enable this, grease must be applied to the pilot bore to prevent the
wheel from seizing onto the hub.
Refer to Adhesives, Fluids, Lubricants, and Sealers for pilot bore lubricant
part number.
Do not use any pene ...
Transmission Assemble (Gen 1)
Special Tools
3-9506289 Universal Adapter
R-0007758 Holding Fixture
S-9407197 Differential Rotating Tool
S-9407198 Differential Bearing Race Wrench
For equivalent regional tools, refer to Special Tools.
Install the clutch and differential housing assembly (1)
onto ...