Recreational vehicle towing means towing the vehicle behind another vehicle, such as a motor home. The two most common types of recreational vehicle towing are known as dinghy towing and dolly towing. Dinghy towing is towing the vehicle with all four wheels on the ground. Dolly towing is towing the vehicle with two wheels on the ground and two wheels up on a device known as a dolly.
Here are some important things to consider before recreational vehicle towing:
Notice:
If the vehicle is towed with all four wheels on the ground, the drivetrain components could be damaged. The repairs would not be covered by the vehicle warranty. Do not tow the vehicle with all four wheels on the ground.
The vehicle was not designed to be towed with all four wheels on the ground. If the vehicle must be towed, a dolly should be used. See “Dolly Towing” that follows for more information.
When dinghy towing a vehicle with an automatic transmission, the vehicle should be run at the beginning of each day and at each RV fuel stop for about five minutes. This will ensure proper lubrication of transmission components.
To dinghy tow the vehicle from the front with all four wheels on the ground:
Remember to reinstall the DLIS fuse once the destination has been reached.
Notice:
If 105 km/h (65 mph) is exceeded while towing the vehicle, it could be damaged. Never exceed 105 km/h (65 mph) while towing the vehicle.
Notice:
Towing the vehicle from the rear could damage it. Also, repairs would not be covered by the vehicle warranty. Never have the vehicle towed from the rear.
The vehicle can be towed from the front using a dolly. To tow the vehicle using a dolly, follow these steps:
Notice:
Towing the vehicle from the rear with the front wheels on the ground could cause transmission damage. Do not tow the vehicle from the rear with the front wheels on the ground.
Towing the VehicleIgnition Positions
The ignition switch has four different positions.
To shift out of P (Park), the ignition must be in ON/RUN and the regular brake
pedal applied.
1 (STOPPING THE ENGINE/LOCK/ OFF): When the vehicle is stopped, turn the ignition
switch to LOCK/ OFF to turn the engine off.
This position locks t ...
Transmission Adaptive Functions
The 6T30/40/45/50 transmission utilizes a line pressure control system during
upshifts to compensate for the normal wear of transmission components. As the apply
components within the transmission wear or change over time, shift time (the time
required to apply a clutch) increase or decreases. ...
Control Valve Body Assembly Installation
Control Valve Body Assembly Installation
Callout
Component Name
1
Low and Reverse Clutch Fluid Passage Seal
2
1-2-3-4 Clutch Fluid Passage Seal
3
Control Valve Body ...