Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Relay Replacement (Attached to Wire Harness)

Chevrolet Sonic Repair Manual / Electrical / Fuses Junctions and Relays / Relay Replacement (Attached to Wire Harness)

Removal Procedure

    Locate the relay. Refer to the Master Electrical Component List to locate
  1. Locate the relay. Refer to the Master Electrical Component List to locate the relay in the vehicle.
  2. Remove any fasteners which hold the relay in place.
  3. Remove any connector position assurance (CPA) devices or secondary locks.
  4. Note:

    Use care when removing a relay in a wiring harness when the relay is secured by fasteners or tape.

  5. Separate the relay (1) from the wire harness connector (2).
Installation Procedure

    Connect the relay (1) to the wire harness connector (2).
  1. Connect the relay (1) to the wire harness connector (2).
  2. Install any connector position assurance (CPA) devices or secondary locks.
  3. Install the relay using any fasteners or tape that originally held the relay in place.
Instrument Panel Fuse Block Access Hole Cover Replacement (Without AAL)
Instrument Panel Fuse Block Access Hole Cover Replacement Callout Component Name 1 Instrument Panel Fuse Block Access Ho ...

Relay Replacement (Within an Electrical Center)
Special Tools EL-43244 Relay Puller Pliers Removal Procedure Remove the electrical center cover. Note: Always note the orientation of the relay. If equipped wi ...

Other materials:

Ambient Air Temperature Sensor Replacement
\/\\//\\\\(in Ambient Air Temperature Sensor Replacement Callout Component Name Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the front bumper fascia opening lower c ...

Camshaft Installation
Special Tools EN-422 Installer For equivalent regional tools, refer to Special Tools. Note: Coat with MoS 2 lubricating paste. Refer to Adhesives, Fluids, Lubricants, and Sealers. Install the intake camshaft (1). Note: Note the identification mark ...

Transmission Control Replacement
Removal Procedure Remove the floor console. Refer to Front Floor Console Replacement. Lift both cable adjustment retainers (1), one for each cable, to release the shift lever and selector lever cable. .1 Pull the shift lever and selector lever cable ret ...

В© 2014-2024 Copyright www.csmans.com
 
0.0099