Chevrolet Sonic Repair Manual: Remote Control Door Lock Receiver Programming and Setup
- Diagnostic Aids
-
The remote control door lock receiver only functions as an antenna, receiving the signals sent by the keyless entry transmitter and forwarding them to the body control module (BCM). The keyless entry software is contained wholly within the BCM.
- Replace and Program ECU or Reprogram ECU
-
This ECU does not require SPS programming or any setup procedures.
Rear Door Lock Cylinder Replacement
Rear Door Lock Cylinder Replacement
Callout
Component Name
1
Rear Side Door Lock Cylinder Opening Cover Screw Access Plu ...
Remote Control Door Lock Receiver Replacement
Remote Control Door Lock Receiver Replacement
Callout
Component Name
Preliminary Procedure
Remove the windshield outside moistu ...
Other materials:
General Description
The factory installed tires are designed to operate satisfactorily with loads
up to and including the full rated load capacity when these tires are inflated to
the recommended pressures.
The following factors have an important influence on tire life:
Correct tire pressures
Correct wheel ...
Engine Coolant Temperature Sensor Replacement (Water Outlet)
Engine Coolant Temperature Sensor Replacement
Callout
Component Name
Preliminary Procedure
Disconnect the negative battery cable. Refer to Battery Negative
Cable Disconnection and Connection.
Drain the cooling system. Ref ...
Charge Air Cooler Outlet Air Hose Replacement
Removal Procedure
Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement.
Loosen the clamp (1) at the charge air cooler outlet pipe (2) to throttle
body (3).
Disconnect the intake air pressure and temperature sensor harness connect ...
0.0059