Chevrolet Sonic manuals

Chevrolet Sonic Owner's Manual: Remote Keyless Entry (RKE) System

Chevrolet Sonic Owner's Manual / In Brief / Initial Drive Information / Remote Keyless Entry (RKE) System

The RKE transmitter may work up to 60m (195 ft) away from the vehicle.

The RKE transmitter can have one of the two symbols for the remote trunk release.


With Remote Start Shown


With Remote Start Shown

Press the key release button to extend the key blade. The key can be used for


Press the key release button to extend the key blade. The key can be used for the ignition and all locks.

Press all doors. to unlock the driver door or
all doors.

Press Lock and unlock feedback can be personalized. See Vehicle Personalization. to lock all doors.


Lock and unlock feedback can be personalized. See Vehicle Personalization.

If equipped, press and hold to release the trunk. or
Press and release  to initiate vehicle to release the trunk.


Press and release locator. to initiate vehicle
locator.

Press and hold seconds to sound the panic alarm. for at least three
seconds to sound the panic alarm.

Press See Keys  and Remote Keyless Entry (RKE) System Operation. again to cancel the panic alarm.


See Keys  and Remote Keyless Entry (RKE) System Operation.

Starting the Engine
The vehicle has a Computer-Controlled Cranking System. It assists in starting the engine and protects components. If the ignition key is turned to START and then released when the engine begins cr ...

Remote Vehicle Start
If equipped with this feature, the engine can be started from outside the vehicle. ...

Other materials:

Personalization Menu (Radio with Touchscreen)
Settings can be made with the ignition ON and the vehicle not moving. Use the audio system controls to access the personalization menus for customizing vehicle features. The following are all possible personalization features. Depending on the vehicle, some may not be available. (Home): Pres ...

Tire and Wheel Assembly-to-Hub/Axle Flange Match-Mounting
Note: After remounting a tire and wheel assembly to a hub/axle flange, remeasure the tire and wheel assembly on-vehicle runout in order to verify that the amount of runout has been reduced and brought to within tolerances. Mark the location of the high spot on the tire and wheel asse ...

Exhaust Camshaft Removal
Remove the camshaft bearing cap bolts in a spiral sequence as shown one turn at a time until there is no spring tension pushing on the camshaft. Note: Mind the markings on the camshaft bearing caps to ensure they will be installed in the same position. Remove the ...

В© 2014-2022 Copyright www.csmans.com
 
0.0072