Chevrolet Sonic Owner's Manual: Remote Lock, Unlock, Start
Select Remote Lock, Unlock, Start and the following may display:
- Remote Unlock Feedback
- Remote Lock Feedback
- Remote Door Unlock
Remote Unlock Feedback
When on, the exterior lamps will flash when unlocking the vehicle with the RKE transmitter.
Select On or Off.
Remote Lock Feedback
This allows selection of what type of feedback is given when locking the vehicle with the RKE transmitter.
Select Lights and Horn, Lights Only, Horn Only, or Off.
Remote Door Unlock
This allows selection of which doors will unlock when pressing
on the RKE transmitter.
Select All Doors or Driver Door Only. When set to Driver Door Only, the driver
door will unlock the first time is pressed
and all doors will unlock when is pressed
a second time. When set to All Doors, all of the doors will unlock at the first
press of .
Power Door Locks
Select Power Door Locks and the following may display:
Auto Door Unlock
Unlock Door Anti Lock Out
Delayed Door Lock
Auto Door Unlock
This allows selection of which of the doors will automa ...
Personalization Menu (Radio with Touchscreen)
Settings can be made with the ignition ON and the vehicle not moving.
Use the audio system controls to access the personalization menus for customizing
vehicle features.
The following are all poss ...
Other materials:
Communication Interface Module Battery Replacement
Communication Interface Module Battery Replacement
Callout
Component Name
Preliminary Procedure
Remove the instrument panel lower compartment. Refer to
Instrument Panel Lower Compartment Replacement
1
...
Crankshaft Rear Oil Seal Replacement
Special Tools
EN-658 Rear Main Seal Installer
For equivalent regional tools, refer to Special Tools.
Removal Procedure
If equipped with automatic transmission, remove the flex plate. Refer
to Automatic Transmission Flex Plate Replacement.
If equipped with a manual transmis ...
K20 Engine Control Module: Programming and Setup
Special Tools
EL-49642 SPS Programming Support Tool
For equivalent regional tools, refer to Special Tools.
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the control module is not properly configured
with the correct ...
0.0061