Chevrolet Sonic Repair Manual: Remote Vehicle Speed Limiting Description and Operation
Certain vehicles equipped with OnStar® now have an additional feature that allows for remote limiting of the vehicle's speed. This OnStar® feature is called Stolen Vehicle Slow-Down and is now part of the OnStar® Stolen Vehicle Assistance service. This feature, when used in conjunction with local law enforcement and strict guidelines at the OnStar® Call Center, will slow the vehicle by interacting with the engine control system.
When the engine control system receives a valid request from the OnStar® telematics communications interface module, it will enter into a reduced engine power/vehicle speed limiting mode, which will decelerate the vehicle. Once the request is active the engine control module begins reducing engine torque to match requested vehicle speed and a REDUCED ENGINE POWER indication is displayed. No DTCs will be set during this process.
Key with Integrated Transmitter Programming
Keys can be programming in various ways using the procedures outlined below.
Using the Replacing Keys procedures will first erase all the known keys from the
vehicle. Any existing keys and any new ...
Theft Deterrent Module Replacement
Theft Deterrent Module Replacement
Callout
Component Name
Preliminary Procedure
Remove the steering column upper trim cover. Refer ...
Other materials:
Rear Compartment Floor Panel Carpet Replacement (Hatchback)
Rear Compartment Floor Panel Carpet Replacement
Callout
Component Name
1
Rear Compartment Floor Panel Carpet Assembly
...
Piston and Connecting Rod Disassemble
Remove the piston with connection rod. Refer to Piston, Connecting Rod,
and Bearing Removal.
Note: Note installation position of the piston in respect of the
connection rod.
Detach the piston from the connection rod.
Note: Do not damage the bore.
Remove ...
Camshaft Timing Chain Removal
Special Tools
EN-952 Fixing Pin
EN-953-A Fixing Tool
EN-955-10 Fixing Pin from EN-955 Kit
For equivalent regional tools, refer to Special Tools.
The engine should be adjusted to TDC.
The crankshaft should be fixed with EN-952 fixing pin.
The camshaft should be fixed with EN-953 ...
0.0078