Warning:
Restraint systems can be damaged in a collision. To help avoid injury and ensure that all parts in need of replacement are replaced:
Do NOT replace single seat belt system components in vehicles that have been in a collision as described above. Always replace the entire seat belt system with the buckle, guide and retractor assembly, which includes the latch and webbing material.
After a minor collision where no automatic restraint device was deployed, seat belt system replacement may not be necessary, unless some of the parts are torn, worn, or damaged.
Rear Seat Shoulder Belt Guide Opening Bezel Replacement
Replacing Safety Belt System Parts after a CrashDistracted Driving
Distraction comes in many forms and can take your focus from the task of driving.
Exercise good judgment and do not let other activities divert your attention away
from the road. Many local governments have enacted laws regarding driver distraction.
Become familiar with the local laws in your ...
OnStar Description and Operation
This OnStar® system consists of the following components:
Telematics communication interface control module
OnStar® three button assembly
Microphone
Cellular antenna
Navigation antenna
Bluetooth® antenna (If equipped)
Back up battery (If equipped)
This system also interfaces wi ...
Exhaust Manifold Heat Shield Installation
Install the exhaust manifold heat shield (2).
Caution: Refer to Fastener Caution.
Install the 3 exhaust manifold heat shield bolts (1) and the washers and
tighten to 8 Y (71 lb in).
...