Chevrolet Sonic Owner's Manual: Retained Accessory Power (RAP)
These vehicle accessories may be used for up to 10 minutes after the engine is turned off:
- Audio System
- Power Windows
- Sunroof
The power windows and sunroof will continue to work for up to 10 minutes or until any door is opened.
The radio will work when the key is in ON/RUN or ACC/ACCESSORY. Once the key is turned from ON/ RUN to LOCK/OFF, the radio will continue to work for 10 minutes after the last input (button press, knob turn) to the radio is detected.
It is possible to turn the radio back on at any time after it has timed out using the Power knob. The radio will be functional for 10 minutes after the last input (button press, knob turn) to the radio is detected.
Engine Heater
The engine heater can provide easier starting and better fuel economy during
engine warm-up in cold weather conditions at or below −18°C (0°F). Vehicles with
an engine heater should be plu ...
Shifting Into Park (Automatic Transmission)
1. Hold the brake pedal down and set the parking brake. See Parking Brake.
2. Move the shift lever into P (Park) by pressing the button on the shift lever
and pushing the lever all the way toward t ...
Other materials:
Parking/Turn Signal Lamp
1. Open the hood. See Hood.
2. Remove the parking/turn signal lamp bulb socket from the headlamp assembly
by turning counterclockwise.
3. Remove the bulb from the bulb socket by pulling it straight out.
4. Install the new bulb in the bulb socket.
5. Install the bulb socket into the headlamp ...
Strut and Shock Absorber Inspection
Note: The strut assembly DOES NOT have to be removed from the vehicle
to perform the following inspection procedure.
Note: A light film of oil on the top portion of the strut is normal.
DO NOT replace the strut for this condition.
Condition 1
Oil or fluid residue only o ...
Tire and Wheel Assembly Runout Measurement - On-Vehicle
Raise and support the vehicle.
Closely inspect each tire for proper and even bead seating.
If any of the tire beads were not properly or evenly seated, reseat the
tire bead, then proceed to step 4. Refer to Tire and Wheel Removal and Installation.
Wrap the circumferenc ...
0.0052