Sunroof
On vehicles with this feature, the sunroof only operates when the ignition is turned to ON/RUN or Retained Accessory Power (RAP) is active.
Open/Close: To open the sunroof, press and hold the rear of the switch. To close the sunroof, press and hold the front of the switch.
Vent: Press and hold the front of the switch to vent the sunroof.
Manually close the sunshade.
The sunroof will not operate if the vehicle has an electrical failure.
Dirt and debris may collect on the sunroof seal or in the track. This could cause an issue with sunroof operation or noise. It could also plug the water drainage system. Periodically open the sunroof and remove any obstacles or loose debris. Wipe the sunroof seal and roof sealing area using a clean cloth, mild soap, and water. Do not remove grease from the sunroof.
Clearcoat Repair without Repainting
Repair Procedure
Thoroughly wash the repair area with Liquid Wash and Wax GM?€‰P/N?€‰1052870
or the equivalent.
Environmental damage may be corrected. Refer to Environmental Fallout
(Acid Rain) or Rail Dust Damage Repair.
Important: Follow all of the instruc ...
Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
Pipe Joint Compound
Note: Three types of sealer are commonly used in engines. These
are RTV sealer, anaerobic gasket eliminator sealer, and pipe joint compound.
The correct sealer and amount must be used in the proper location to prevent
oil leaks. DO NOT interchange the 3 ...
Internal Components Removal
Internal Components Removal
Callout
Component Name
1
1??? Clutch Backing Plate Retainer Ring
Warning: The retainer is under tension. Use care when removing
or installing the retainer. Personal injury could r ...