Chevrolet Sonic Repair Manual: Roof Outer Panel Replacement (5HB)
- Removal Procedure
-
- Disable the SIR system. Refer to SIR Disabling and Enabling.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Remove all related panels and components.
- Visually inspect the damage. Repair as much of the damage as possible.
- Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
- Locate and mark all factory welds.
- Drill all factory welds (1). Note the number and location of welds for installation of the service assembly.
- Cut the adhesive with an appropriate tool.
- Remove the damaged roof panel?€‰(1).
Warning:
Refer to Approved Equipment for Collision Repair Warning.
- Installation Procedure
-
- Drill 8?€‰mm (5/16?€‰in)
holes for plug welding along the edges of the service panel as noted from the original panel (1).
- Clean and prepare the attaching surfaces for welding.
- Apply one-part windshield urethane adhesive as noted from the original panel (1).
- Position the roof panel?€‰(1) on the vehicle.
- Verify the fit of the panel.
- Clamp the panel into position.
- Plug weld accordingly (1).
- Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
- Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
- Install all related panels and components.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Enable the SIR system. Refer to SIR Disabling and Enabling.
- Drill 8?€‰mm (5/16?€‰in)
Roof Outer Panel Replacement (4NB)
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Disable the SIR system. Refer to SIR Disabling and Enabling.
Disconnect the nega ...
Roof Rail Front Assist Handle Replacement
Roof Rail Front Assist Handle Replacement
Callout
Component Name
1
Roof Rail Front Assist Handle Fastener (Qty:?€‰2) ...
Other materials:
Front Side Door Lock Cylinder Coding (Non Free Wheeling)
The door lock cylinder uses 8 of the 8 cut positions. The tumbler positions are
staggered from side to side, 4 on one side and 4 on the other, are not self-retaining,
and are not snap in.
Note: All lock cylinders for side milled keys have right and left
tumblers. The locat ...
Front Side Door Weatherstrip Replacement - Body Side
Front Side Door Weatherstrip Replacement - Body Side
Callout
Component Name
Preliminary Procedures
Remove the upper center pillar trim. Refer to Center Pillar Upper
Trim Panel Replacement.
Remove the lower center pillar t ...
Throttle Body Inspection and Cleaning
Note: Over extended time and mileage, deposits may accumulate on the
back of the throttle valve plate. The source of the deposit is exhaust gas.
Typically these deposits pose no problem. Occasionally the deposit may accumulate
to a point where perceived pedal effort or throttle valve mov ...
0.005