Chevrolet Sonic Owner's Manual: Safety Belt Pretensioners
This vehicle has safety belt pretensioners for front outboard occupants. Although the safety belt pretensioners cannot be seen, they are part of the safety belt assembly. They can help tighten the safety belts during the early stages of a moderate to severe frontal, near frontal, or rear crash if the threshold conditions for pretensioner activation are met. And, if the vehicle has side-impact airbags, safety belt pretensioners can help tighten the safety belts in a side crash or a rollover event.
Pretensioners work only once. If the pretensioners activate in a crash, the pretensioners and probably other new parts of the vehicle's safety belt system will need to be replaced. See Replacing Safety Belt System Parts after a Crash.
Shoulder Belt Height Adjuster
The vehicle has a shoulder belt height adjuster for the driver and right front
passenger seating positions.
Adjust the height so the shoulder portion of the belt is on the shoulder and
not fallin ...
Rear Safety Belt Comfort Guides
Rear safety belt comfort guides may provide added safety belt comfort for older
children who have outgrown booster seats and for some adults. When installed on
a shoulder belt, the comfort guide p ...
Other materials:
Input Speed Sensor Replacement
Removal Procedure
Remove the control solenoid valve and transmission control module assembly.
Refer to Control Solenoid Valve and Transmission Control Module Assembly
Replacement.
Remove the input speed sensor bolt (2) M6 x 23.
Unlock t ...
Battery Positive and Negative Cable Replacement
Removal Procedure
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove the fuse block and battery positive cable cover.
Remove the battery tray. Refer to Battery Tray Replacement.
Remove the battery posit ...
Crankshaft Rear Oil Seal Installation
Special Tools
EN-658-1 Installer
EN-235-6 Installer
For equivalent regional tools, refer to Special Tools.
Slide the crankshaft rear oil seal (2) across the EN-235-6 installer (1).
Install the crankshaft rear oil seal (1) with EN-235-6 installer ...
0.0058