Chevrolet Sonic Owner's Manual: Safety System Check
Now and then, check that the safety belt reminder light, safety belts, buckles, latch plates, retractors, and anchorages are all working properly. Look for any other loose or damaged safety belt system parts that might keep a safety belt system from doing its job. See your dealer to have it repaired. Torn or frayed safety belts may not protect you in a crash. They can rip apart under impact forces. If a belt is torn or frayed, get a new one right away.
Make sure the safety belt reminder light is working. See Safety Belt Reminders.
Keep safety belts clean and dry. See Safety Belt Care.
Safety Belt Extender
If the vehicle's safety belt will fasten around you, you should use it.
But if a safety belt is not long enough, your dealer will order you an extender.
When you go in to order it, take the hea ...
Safety Belt Care
Keep belts clean and dry.
Warning
Do not bleach or dye safety belts. It may severely weaken them. In a crash,
they might not be able to provide adequate protection. Clean safety belts only with
...
Other materials:
Heated Seat Control Module Programming and Setup
The seat heating control module must be programmed with the proper calibration
software. The module stores and utilizes this information however if it is not properly
configured with the correct calibration software, the seat heating control module
will not control all of the vehicle features ...
Torque Converter Installation
Torque Converter Installation
Callout
Component Name
1
Torque Converter Assembly
Note: Failure to lower the torque converter straight down
could damage the torque converter clutch lip seal inside the torque ...
Manual Transmission Shift Lever and Selector Lever Cable Replacement
Removal Procedure
Remove the battery tray. Refer to
Battery Tray Replacement.
\i
Disconnect the shift lever and selector cable ends (1)
from the transmission shift lever and selector levers.
Pull the cable retainers (2) to release the shift
leve ...
0.0118