Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Seat Belt Latch Stop Installation

Chevrolet Sonic Repair Manual / Body / Doors and Enclosures / Doors / Seat Belt Latch Stop Installation



Seat Belt Latch Stop Installation

Callout

Component Name

Preliminary Procedure

  1. Locate the hole in the seat belt webbing where the original seat belt stop button was located.
  2. If the original hole in the seat belt webbing is not visible, perform the following:
  • If either the right or left stop button is missing use the opposing seat belt as a reference.
  • With the opposing seat belt fully stowed, measure the distance between the seat belt lower anchor and the stop button.
  • Using the measurement obtained above, measure and mark the location of the missing stop button on the center of the seat belt webbing.
  • Ensure the seat belt latch plate is located above the mark or original hole.
  • 1

    Seat Belt Stop Button

    Procedure

    1. Work the male half of the stop button through the hole in the webbing or at the marked location.
    2. Align the female half of the stop button with the male half of the stop button.
    3. Snap the two halves together.
    4. Trim off any access of the male half of the stop button flush with the female half of the stop button.

    Tip:

    Ensure the male half of the stop button is facing forward in the vehicle in order to ensure the stop button will not snag customers clothing.

    Instrument Panel Upper Compartment Door Latch Replacement
    Instrument Panel Upper Compartment Door Latch Replacement Callout Component Name 1 Instrument Panel Upper Compartment Do ...

    Hood Assembly
    ...

    Other materials:

    Bluetooth (Overview)
    For vehicles equipped with Bluetooth capability, the system can interact with many cell phones, allowing: Placement and receipt of calls in a hands-free mode. Sharing of the cell phone’s address book or contact list with the vehicle. To minimize driver distraction, before driving, and ...

    Front Wheel Drive Shaft Replacement
    Special Tools J-45859 Axle Remover For regional equivalent tools, refer to Special Tools. Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the front suspension skid plate bolts (1) and the front suspen ...

    Knock Sensor System Description
    Circuit/System Description The knock sensor system enables the engine control module (ECM) to control the ignition timing for the best possible performance while protecting the engine from potentially damaging levels of detonation. The ECM uses the knock sensor system to test for ...

    © 2014-2024 Copyright www.csmans.com
     
    0.0066