Chevrolet Sonic Repair Manual: Seat Belt Service Precautions
- Do not bleach or dye the seat belt webbing. Use only the following items in order to clean the seat belt webbing:
- A mild soap and water solution
- A soft brush or cloth
- Keep sharp edges and damaging objects away from the seat belts. Avoid bending or damaging any part of the seat belt buckle or the latch plate. Replace any seat belts which are cut or damaged in any way.
- Use only the correct seat belt anchor bolts/screws and tighten the anchor bolts/screws to the correct torque value. Refer to Fastener Tightening Specifications. When installing seat belt anchor bolts, start the bolt by hand to ensure that the bolt is threaded straight.
- Some seat belts and retractors require service as a set, with service replacement parts only. Do not attempt to repair to individual components that require service as a set.
- Verify that the replacement part number is correct for the vehicle at that seating position. Do not substitute a seat belt from a different seating position.
Note:
If the vehicle has been in a collision, refer to Repairs and Inspections Required After a Collision for additional information.
Seat Belt Latch Stop Installation
Seat Belt Latch Stop Installation
Callout
Component Name
Preliminary Procedure
Locate the hole in the seat belt webbing where the o ...
Seat Belt System Description and Operation
Restraint System
Note: If the vehicle has been in a collision, refer to Repairs
and Inspections Required After a Collision.
The vehicle has front and rear seat belts that are th ...
Other materials:
Air Conditioning Condenser Replacement (LUV)
Air Conditioning Condenser Replacement
Callout
Component Name
Preliminary Procedure
Drain the refrigerant. Refer to Refrigerant Recovery and Recharging
Remove the front bumper fascia assembly. Refer to Front Bumper Fascia ...
Engine Flywheel Replacement
Engine Flywheel Replacement
Callout
Component Name
Preliminary Procedure
Remove the clutch pressure and driven Plate . Refer to Clutch Pressure
and Driven Plate Replacement.
Special Tools
EN-652 Flywheel Holder
...
Camshaft Cover Installation
Clean the sealing surfaces.
Note: The thickness of the sealing bead should be 2 mm (0.0787 in).
Apply sealing compound to areas (1) and (2). Refer to Adhesives, Fluids,
Lubricants, and Sealers.
Note: The installation procedure sho ...
0.0094