Chevrolet Sonic Owner's Manual: Seats and Restraints
- Head Restraints
- Front Seats
- Rear Seats
- Safety Belts
- Why Safety Belts Work
- Questions and Answers About Safety Belts
- How to Wear Safety Belts Properly
- Lap-Shoulder Belt
- Safety Belt Use During Pregnancy
- Safety Belt Extender
- Safety System Check
- Safety Belt Care
- Replacing Safety Belt System Parts after a Crash
- Airbag System
- Airbag System
- Where Are the Airbags?
- When Should an Airbag Inflate?
- What Makes an Airbag Inflate?
- How Does an Airbag Restrain?
- What Will You See after an Airbag Inflates?
- Passenger Sensing System
- Servicing the Airbag-Equipped Vehicle
- Adding Equipment to the Airbag-Equipped Vehicle
- Airbag System Check
- Replacing Airbag System Parts after a Crash
- Child Restraints
Roof
Sunroof
On vehicles with this feature, the sunroof only operates when the ignition is
turned to ON/RUN or Retained Accessory Power (RAP) is active.
Open/Close: To open the sunroof, press and hol ...
Head Restraints
Warning
With head restraints that are not installed and adjusted properly, there is
a greater chance that occupants will suffer a neck/ spinal injury in a crash. Do
not drive until the head restr ...
Other materials:
Rear Compartment Sill Trim Plate Replacement
Rear Compartment Sill Trim Plate Replacement
Callout
Component Name
Preliminary Procedure
Partially remove the rear compartment opening weatherstrip. Refer to
Rear Compartment Lid Weatherstrip Replacement.
...
Inflatable Restraint Module Handling and Scrapping
Special Tools
EL-38826 SIR Deployment Harness
EL-39401-B SIR Deployment Fixture
For equivalent regional tools, refer to Special Tools.
Live and Undeployed Air Bag
Warning: Refer to SIR Inflator Module Handling and Storage Warning.
Take special care when handling or s ...
Oil Pump Cleaning and Inspection
Remove the external rotor with the internal rotor.
Visually inspect the components.
Install the external and the internal rotors.
Inspect the axial clearance of the rotors in respect to the control unit
housing upper edge.
Specifications
Permissible measurement is 0.02?E.058 ...
0.0074