Chevrolet Sonic Repair Manual: Secondary

Multi-Axis Acceleration Sensor Module Programming and Setup

Note: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the Multi-axis Acceleration Sensor or Inertia Sensor Module (IMU) is not pro ...

SIR Deployed Inflator Modules Are Hot Warning

Warning: After deployment, the metal surfaces of the SIR component may be very hot. To help avoid a fire or personal injury: Allow sufficient time for cooling before touching any metal su ...

Other materials:

Brake Fluid
The brake/clutch master cylinder reservoir is filled with DOT 3 brake fluid as indicated on the reservoir cap. See Engine Compartment Overview  for the location of the reservoir. There are only two reasons why the fluid level in the reservoir might go down: The fluid level goes down ...

Sunroof Window Seal Replacement
Removal Procedure Remove the sunroof window panel. Refer to Sunroof Window Replacement. Remove the seal from the window panel frame by pulling the seal away at one point and continuing around the perimeter of the frame. Clean around the edge of the inside surf ...

Neutral - Engine Running (Gen 1)
When the gear selector is moved to the Neutral (N) position, the hydraulic and electrical system operation is identical to Park (P) range. However, if Neutral is selected after the vehicle was operating in Reverse (R), the normally-high 35R pressure control solenoid 2 is commanded OFF and the ...