Chevrolet Sonic Repair Manual: Shoulder Belt Replacement - Rear (Hatchback)

Chevrolet Sonic Repair Manual / Body / Restraints / Primary / Shoulder Belt Replacement - Rear (Hatchback)

Shoulder Belt Replacement - Rear
Callout	Component Name
Preliminary Procedures Remove the rear seat cushion. Refer to Rear Seat Cushion Removal and Installation. Remove the body lock pillar upper trim. Refer to Body Lock Pillar Upper Trim Panel Replacement. Remove the quarter inner trim finish panel. Refer to Quarter Inner Trim Finish Panel Replacement.
1	Rear Seat Shoulder Belt Fastener Caution: Refer to Fastener Caution. Tighten 45?€‰Y?€‰(33?€‰lb?€‰ft)
2	Rear Seat Shoulder Belt Retractor Fastener Tighten 45?€‰Y?€‰(33?€‰lb?€‰ft)
3	Rear Seat Shoulder Belt Bracket Fastener Tighten 45?€‰Y?€‰(33?€‰lb?€‰ft)
4	Rear Seat Shoulder Belt Assembly

Seat Belt System Description and Operation

Restraint System Note: If the vehicle has been in a collision, refer to Repairs and Inspections Required After a Collision. The vehicle has front and rear seat belts that are th ...

Shoulder Belt Replacement - Rear (Sedan)

Shoulder Belt Replacement - Rear Callout Component Name Preliminary Procedure Remove the rear window panel trim. Refer to Rear ...

Other materials:

Tire Rotation
Tires should be rotated every 12 000 km (7,500 mi). See Maintenance Schedule. Tires are rotated to achieve a uniform wear for all tires. The first rotation is the most important. Anytime unusual wear is noticed, rotate the tires as soon as possible, check for proper tire inflation pressure, an ...

Adhesive Installation of Rear Windows
Warning: Refer to Glass and Sheet Metal Handling Warning. Use a urethane adhesive systems which meet GM Specification GM?€‰3651G. Remove all mounds or loose pieces of urethane adhesive from the pinchweld area. If the original window is being reused, remove all but approxi ...

Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto the balancer. The pilot bore (on the hub side of the wheel) is machined to be concentric to very tight non - standard tolerances. The bottom cap bore is not machined to this same degree of precision. Accurate mac ...

0.0074