Chevrolet Sonic Repair Manual: Side Windows

Urethane Adhesive Description

For replacement of any adhesive-installed window, use the full cut method only. Use an adhesive that is approved by GM, Specification GMW-15672. Use these materials based on specific manufacturer. D ...

Power Windows Description and Operation

Power Window System Components The power window system consists of the following components: Driver window switch Front passenger window switch Left rear window switch Right re ...

Other materials:

Relay Replacement (Attached to Wire Harness)
Removal Procedure Locate the relay. Refer to the Master Electrical Component List to locate the relay in the vehicle. Remove any fasteners which hold the relay in place. Remove any connector position assurance (CPA) devices or secondary locks. Note: Use care w ...

Electronic Ignition System Description
Electronic Ignition System Operation The electronic ignition system produces and controls the high energy secondary spark. This spark ignites the compressed air/fuel mixture at precisely the correct time, providing optimal performance, fuel economy, and control of exhaust emissions. ...

Engine Oil Cooler Housing Installation
Clean the engine oil cooler housing to thermostat housing sealing surfaces. Install 2 NEW gaskets. h.\.\,.\\..,v:..// Install the engine oil cooler inlet pipe (3). Install the engine oil cooler housing (1) and the 5 engine oil cooler bolts (2) and t ...