Chevrolet Sonic Owner's Manual: SiriusXM Radio Messages
UPDATING: The encryption code in the receiver is being updated, and no action is required. This process should take no longer than 30 seconds.
NO SIGNAL: The system is functioning correctly, but the vehicle is in a location that is blocking the SiriusXM signal. When the vehicle is moved into an open area, the signal should return.
LOADING: The audio system is acquiring and processing audio and text data. No action is needed. This message should disappear shortly. OFF AIR: This channel is not currently in service. Tune in to another channel.
CH UNAVAILABLE: This previously assigned channel is no longer assigned. Tune to another station. If this station was one of the presets, choose another station for that preset button.
RADIO ID: If tuned to channel 0, this message alternates with the SiriusXM Radio eight-digit radio ID label. This label is needed to activate the service.
CHECK XM TUNER: If this message does not clear within a short period of time, the receiver could have a fault. Consult with your dealer.
Storing an SiriusXM Channel
Drivers are encouraged to set up XM channel favorites while the vehicle is not
moving. Tune to favorite stations using the pushbuttons, favorites button, and steering
wheel controls. See Defensive ...
Radio Reception
Frequency interference and static can occur during normal radio reception if
items such as cell phone chargers, vehicle convenience accessories, and external
electronic devices are plugged into th ...
Other materials:
Steering Linkage Outer Tie Rod Inspection
Special Tools
GE-8001 Dial Indicator Set
For equivalent regional tools, refer to Special Tools.
Note: This inspection procedure does not supersede local government
required inspections that have more stringent requirements.
Inspect the outer tie rod seal. If the outer tie rod ...
Camshaft Position Actuator Adjuster Removal
Special Tools
EN-6340 Camshaft Adjuster Locking Tool
EN-6628-A Camshaft Locking Tool
For equivalent regional tools, refer to Special Tools.
Note: The right half of the EN-6340 locking tool can be
recognized by the lettering "right", arrow, on the tool.
Pre ...
Reverse (Gen 2)
When the gear selector lever is moved to the Reverse (R) position (from the Park
position) the normally-low 35R pressure control solenoid is commanded ON and the
following changes occur in the transmission? hydraulic and electrical systems:
3-5-Reverse Clutch Applies
Manual Valve
...
0.0102