|
Illustration |
Tool Number/ Description |
|---|---|
|
EN-45059 J-45059 Angle Meter |
Rear Wheelhouse Panel Liner Extension Replacement
Center Pillar Reinforcement ReplacementTire and Wheel Assembly Runout Measurement - On-Vehicle
Raise and support the vehicle.
Closely inspect each tire for proper and even bead seating.
If any of the tire beads were not properly or evenly seated, reseat the
tire bead, then proceed to step 4. Refer to Tire and Wheel Removal and Installation.
Wrap the circumferenc ...
Crankshaft Rear Oil Seal Installation
Special Tools
EN-658-1 Installer
EN-235-6 Installer
For equivalent regional tools, refer to Special Tools.
Slide the crankshaft rear oil seal (2) across the EN-235-6 installer (1).
Install the crankshaft rear oil seal (1) with EN-235-6 installer ...
Internal Components Removal
Internal Components Removal
Callout
Component Name
1
1??? Clutch Backing Plate Retainer Ring
Warning: The retainer is under tension. Use care when removing
or installing the retainer. Personal injury could r ...