Chevrolet Sonic Repair Manual: Special Tools
|
Illustration |
Tool Number/Description |
|---|---|
|
CH-41013 J 41013 Rotor Resurfacing Kit |
|
CH-42450-A J 42450-A Wheel Hub Resurfacing Kit |
|
CH-45101 J 45101 Hub and Wheel Runout Gauge |
|
CH-45101-100 J 45101-100 Conical Brake Rotor Washers |
Rear Wheel Bearing and Hub Replacement (Disc Brake)
Special Tools
EN–45059 Angle Meter
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Raise and suitably support the vehicle. Refer to Lifting and Jacking
...
Brake Calipers
...
Other materials:
Vehicle Yaw Sensor Learn
The yaw sensor does not require calibration often. Calibration of the yaw rate
sensor might be required after certain service procedures are performed. Some of
these procedures are as follows:
Electronic brake control module (EBCM) replacement
Multi-axis acceleration sensor replacement
...
Oil Pump Cleaning and Inspection
Remove the external rotor with the internal rotor.
Visually inspect the components.
Install the external and the internal rotors.
Inspect the axial clearance of the rotors in respect to the control unit
housing upper edge.
Specifications
Permissible measurement is 0.02?E.058 ...
Drive Range, First Gear (Gen 2)
As the vehicle speed increases, the transmission control module (TCM) receives
input signals from the automatic transmission input and output speed sensors, throttle
position sensor and other vehicle sensors to determine the precise moment to de-energize
or ?urn OFF?the shift solenoid, and to ...
0.0059