Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Special Tools

Illustration

Tool Number/ Description


CH-24319-B

CH-43631

J-24319-B

J-43631

Ball Joint Remover


CH-50559

Wheel Hub / Bearing Remover / Installer Kit


CH-51035

Rear Axle Supporter Adapter


CH-51095

J-39642

Shock Nut Removal Tool Set


DT-50187

Rear Axle Supporter

Rear Suspension Description and Operation
This vehicle has a beam rear suspension system consisting of the following components: An axle with integral trailing arms A cross beam Two coil springs Two standard shock absorbers ...

Trim Height Inspection
Trim Height Measurement Trim height is a predetermined measurement relating to vehicle ride height. Incorrect trim heights can cause the vehicle to bottom out over bumps, damage to the ...

Other materials:

Hood Adjustment
Hood Adjustment Callout Component Name 1 Hood Caution: Refer to Fastener Caution. Procedure Loosen the 4 hood hinge nuts. Adjust the hood in order to obtain an even gap on both sides between ...

Instrument Panel Center Molding Replacement (With U58)
Instrument Panel Center Molding Replacement Callout Component Name 1 Instrument Panel Center Molding Assembly Procedure Use a flat bladed plastic trim tool in the shown locations, then rotate the trim tool 90 ...

Body Control Module Programming and Setup
Note: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the control module is not properly configured with the correct calibration software, the control module will not control all of the vehicle features properly. Ensure th ...

В© 2014-2026 Copyright www.csmans.com
 
0.0053