Chevrolet Sonic Repair Manual: Special Tools
|
Illustration |
Tool Number / Description |
|---|---|
|
CH?E9376 Holding Wrench |
|
CH?E9400 J-45859 Hub Spindle Remover |
|
DT-6332 Seal Protector |
|
DT-35910 CH-8904 J-35910 Drive Axle Boot Clamp Pliers |
|
DT?E0186 Wheel Hub Holding Tool |
|
EN-956?E KM-956?E Extension |
Front Wheel Drive Shaft Seal Replacement - Torque Converter Housing Side
Front Wheel Drive Shaft Seal Replacement - Torque Converter Housing
Side
Callout
Component Name
1
Front Wheel Drive S ...
Wheel Drive Shaft Inner Joint Inspection
Inspection Procedure
Remove the front wheel drive shaft inner joint and boot. Refer to Front
Wheel Drive Shaft Replacement.
Remove the wheel drive shaft tripod bushing ...
Other materials:
Roof Rear Header Panel Replacement (5HB)
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Disable the SIR system. Refer to SIR Disabling and Enabling.
Disconnect the negative battery cable. Refer to Battery Negative Cable
Disconnection and Connection.
Remove all ...
Master Cylinder Replacement
Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning.
Caution: Refer to Brake Fluid Effects on Paint and Electrical
Components Caution.
Place the ignition switch in the OFF position.
Remove the battery. Refer to Battery Replacement.
Disconnect ...
Secondary Air Injection System Description
The Secondary Air Injection System aids in the reduction of hydrocarbon exhaust
emissions during a cold start. This occurs when the start-up engine coolant temperature
(ECT) is between −10 to +56°C (14?E33°F), the intake air temperature (IAT) is greater
than −10°C (14°F) and it ...
0.0063