Chevrolet Sonic Repair Manual: Special Tools
|
Illustration |
Tool Number/Description |
|---|---|
|
3-9607433 Transmission Support |
|
DT-586 J-23129 KM-586 Universal Seal Remover |
|
DT-3289-20 J-3289-20 Holding Fixture |
|
DT-7004 J-6125-1B KM-J-7004 Slide Hammer with Adapter |
|
DT-8059 J-8059 KM-396 Snap Ring Pliers-Parallel Jaw |
|
DT-8092 J-8092 KM-J-8092 DW340-010 Driver Handle |
|
DT-21366 J-21366 Converter Holding Strap |
|
DT-28585 J-28585 KM-J-28585 Snap Ring Remover |
|
DT-39890 J-39890 Transmission Holding Fixture Adapter |
|
DT-41229 J-41229 Manual Shaft Pin Installer |
|
DT-45096 J-45096 Transmission Oil Cooling System Flush and Flow Test Tool |
|
DT-45096-50 J-45096-50 Transmission Oil Cooler Flush Adapter |
|
DT-45201 J-45201 DT-48203 Cooler Line Seal Remover |
|
DT-46409 J-46409 KM-922 Torque Converter Lifting Handles |
|
DT-46620 J-46620 Seal Installer |
|
DT-46625 J-46625 Holding Fixture |
|
DT-46625-10 J-46625-10 Holding Fixture Adapter |
|
DT-47694 Spring Compressor |
|
DT-47790 Seal Installer |
|
DT-47791-A Seal Installer |
|
DT-47792 Seal Installer |
|
DT-47793 Differential Rotating Tool |
|
DT-47794 Spring Compressor |
|
DT-47796 Seal Protector |
|
DT-47797 Spring Installer |
|
DT-47798 Seal Protector |
|
|
DT-47799 Clutch Piston Spring Compressor |
|
DT-47805 Seal Protector |
|
DT-47807 Clutch Piston Seal Installer |
|
DT-47811-S1 Lift Plate |
|
DT-47951-1 Seal Protector |
|
DT-47951-2 Spring Compressor |
|
DT-48056 Spring Compressor Bridge |
|
DT-48270 Spring Installer |
|
DT-48271 Seal Protector |
|
DT-48272 Spring Installer |
|
DT-48273 Seal Protector |
|
DT-48274 Spring Compressor |
|
DT-48277 Differential Rotating Tool |
|
DT-48550 Detent Lever Pin Remover |
|
DT-48616 Control Solenoid Test Plate |
|
DT-48616-10 Adapter Harness |
|
DT-48866 Spring Compressor |
|
DT-48903 Spring Compressor |
|
DT-49101 Seal Installer |
|
DT-49131 Seal Staking Tool |
|
DT-50369 Seal Protector |
|
EL-35616 J 35616 Terminal Test Probe Kit |
|
EL-38522 J-38522 Variable Signal Generator |
|
EN-21867 GE 21867 J-21867 Pressure Gauge |
|
EN-45059 J-45059 Angle Meter |
|
EN-680770 M-680770 Universal Sliding Malet |
|
EN-9703392 J-9703392 Hydraulic Jack |
|
GE-5586-A J-5586-A Snap Ring Pliers |
|
GE-21867-A J-21867-A Oil Pressure Gauge Kit |
|
GE-34673 J-34673 Flat Gauge Bar |
Other materials:
Lower Anchor and Top Tether Anchor Locations
(Top Tether Anchor): Seating positions
with top tether anchors.
(Lower Anchor): Seating positions
with two lower anchors.
To assist in locating the lower anchors, each seating position with lower anchors
has two labels, near the crease between the seatback and the seat cushion.
To ass ...
Dinghy Towing All except RS Model with Automatic Transmission
When dinghy towing a vehicle with an automatic transmission, the vehicle should
be run at the beginning of each day and at each RV fuel stop for about five minutes.
This will ensure proper lubrication of transmission components.
To dinghy tow the vehicle from the front with all four wheels on ...
Instrument Panel Lower Trim Pad Cover Replacement (With AAL)
Instrument Panel Lower Trim Pad Cover Replacement
Callout
Component Name
Preliminary Procedure
Disable the SIR system. Refer to SIR Disabling and Enabling.
1
Instrument Panel Lower Trim Pad Fastener ...
0.0051