Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Special Tools (MIT Tool Instructions)

Chevrolet Sonic Repair Manual / Accessories / Personal Communications / Special Tools (MIT Tool Instructions)

Bluetooth Pairing for Vehicles with Radio RPO: UF7

Either reset the pin code on the radio to 0000, or go under Device Info on the radio and see what the pin code is (to enter it later on the MIT).

Holden Radio Bluetooth Pairing Instructions
For all other Radios
Testing the Bluetooth Function

Standard Bluetooth Pairing/Bonding

Streaming Audio

To Place a Test Call

Testing the AUX/Line-In Function

Testing the USB Function

Troubleshooting Guide

If the MIT unit is still not working properly after following the below troubleshooting, the unit is malfunctioning and should be repaired or replaced.

Unit not Working

  • Verify the MIT is powered on correctly as indicated by the green Power LED.
  • If Power LED is not illuminated, verify USB power source is working properly.
  • If USB power adapter is being used to power the MIT, check and, if necessary, replace the fuse in adapter.
Problem with Aux/Line-In Test

  • Verify Aux/Line- In test cable is inserted properly into the vehicle audio input jack. Verify the MIT is in Aux/Line-In mode as indicated by the red AUX LED.
  • Verify the vehicle audio system is in Auxiliary or Line-in mode. Verify the vehicle audio system volume is turned up and not in mute mode.
Problem with USB Test

  • Verify MIT is in USB mode as indicated by the red USB LED. Verify the vehicle audio system is in USB mode.
  • Verify the vehicle audio system volume is turned up and not in mute mode.
Problem with Bluetooth Pairing

  • Delete previous devices stored in the device list of the radio and the pair the MIT
  • Remove USB cable, and then reconnect to reset the MIT. Carefully follow the bonding instructions for the correct Passkey procedure.
Problem with Bluetooth Test Call Audio

  • Verify the MIT is paired with the vehicle. This is indicated by the quick flashing Bluetooth LED.
  • Audio system should have indicated the MIT is bonded.
Special Tools
Illustration Tool Number/Description EL–50334–20 Multi-Media Interface Tester (MIT) EL– ...

Wireless Communication Interface Antenna Replacement
Wireless Communication Interface Antenna Replacement Callout Component Name Preliminary Procedure Remove the communication inte ...

Other materials:

Cruise Control Description and Operation
Cruise control is a speed control system that maintains a desired vehicle speed under normal driving conditions at speeds above 40 km/h (25 mph). Steep grades may cause variations in the selected vehicle speeds. The following are the main components of the Cruise Control System: ...

Fuel Tank Draining
Warning: Refer to Gasoline/Gasoline Vapors Warning. Note: The fuel tank must be drained with a suitable, commercially-available fuel removal unit and suction hose - follow safety regulations and national legislation. The fuel tank is fitted with a refill limit float valve. T ...

Oil Pressure Relief Valve Replacement
Removal Procedure Remove the oil pan. Refer to Oil Pan Replacement. Remove the oil pressure relief valve closure bolt (1). Remove the oil pressure relief valve assembly (2). Separate the piston (3) and the spring (4). Warning: Bod ...

© 2014-2024 Copyright www.csmans.com
 
0.0063