Chevrolet Sonic Repair Manual: Steering Gear Assembly

Power Steering Control Module Programming and Setup

The following service procedures require either a programming or a setup event performed for a complete repair. Power Steering Control Module Replacement If the steering column power stee ...

Steering Gear Boot Replacement

Special Tools CH-804  Tensioner For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicl ...

Other materials:

Fog Lamps (RS)
To replace the front fog lamp bulb: Locate the fog lamp located under the front fascia. Remove the cap from the back of the fog lamp assembly. Disconnect the electrical connector from the fog lamp bulb assembly. Remove the bulb by turning it counterclockwise and pulling it straight out ...

Ball Joint Inspection
Caution: Refer to Vehicle Lifting and Jacking Caution. Raise the front of the vehicle to allow the front suspension to hang free. Grasp the tire at the top and the bottom. Move the top of the tire in an in-and-out motion. Look for any horizontal movement of the knuckle relativ ...

Knock Sensor System Description
Circuit/System Description The knock sensor system enables the engine control module (ECM) to control the ignition timing for the best possible performance while protecting the engine from potentially damaging levels of detonation. The ECM uses the knock sensor system to test for ...