Special Tools
CH-804 Tensioner
For equivalent regional tools, refer to Special Tools.
Note:
Place match marks on the steering linkage inner tie rod nut and the steering linkage inner tie rod before removing. During installation of the nut, align the match marks.
Note:
The steering gear boot must seat in the appropriate groove on the steering gear.
Fuses and Circuit Breakers
The wiring circuits in the vehicle are protected from short circuits by a combination
of fuses, circuit breakers, and fusible thermal links. This greatly reduces the
chance of fires caused by electrical problems.
Look at the silver-colored band inside the fuse. If the band is broken or melted, ...
Rear Seat Back Cushion Panel Replacement
Rear Seat Back Cushion Panel Replacement
Callout
Component Name
Preliminary Procedure
Remove the rear seat back cushion. Refer to Rear Seat Back Cushion
Removal and Installation
Remove the rear seat head restraint guide. ...
Fuel Pump Flow Control Module Replacement
Fuel Pump Flow Control Module Replacement
Callout
Component Name
Preliminary Procedures
Disconnect the battery negative cable. Refer to Battery Negative
Cable Disconnection and Connection.
Remove the right rear compartmen ...